Fairing pushy in clip things

[Ian T]

Does anyone know the sizes of the fairing push in plastic clips. I believe there are two sizes.

Also has anyone purchased any from anywhere that offer a good quality against a reasonable price. Main places appear very expensive.

Cheers

Ian

[Gert]

Not sure of the push rivet size on your model. On my 1st gen Wee, the sizes are one 8mm and the rest 6mm, if I remember correctly.
Perhaps the info in https://www.v-strom.co.uk/smf/index.php?topic=37584.0 can clarify a bit more.
Have you tired searching on ebay as a less expensive option to the dealers?

[Ian T]

Thanks Gert

Just found as near measurements as I can funny enough from Wemoto.

They sell two sizes for the 13 model:

25mm long. 17mm top cap. 6.1mm diameter push pin.
20.5mm long. 12mm top cap. 4.7mm diameter push pin.

So I think given most appear to be sold as 5mm. 6mm. 7mm etc that they go to the nearest size.

So in this case 6mm and 5mm.

I will order some from the eBay place and just see what they are like.

Cheers

Ian

[Gert]

It is good to hear that you have found a replacement source.

Out of interest, do you perhaps know where all is the 4.7mm rivet used? I find it that Suzuki end up with two rivet sizes, instead of remaining with one size fits all of the 6mm.

A quick look at the parts list, shows part number 09409-06314-5PK, but the size is not listed.

[The Doctor 46]

I bought some off ebay for my bike. I didn't know there are two sizes and the ones I got were too big so, if there are only two sizes, you need the small ones. Hope this helps. 

[Gert]

A bit further searching through 1st gen Wee parts list, confirms the use of same part number 09409-06314-5PK is the same part number that is used on the L2 -L6 models.
When I cross reference this part number in relation to the cowling, the gauges trim and the rear panels of my 1st gen, then this  09409-06314-5PK part number is a 5.9m (6mm) push rivet.