Throttle body sync pipes extension

[Hessy]

Hi to all,
I have recently fitted extension tubes to my DL1000 and using the little magnetic door clips you can get for kitchen doors etc I drilled 2 holes in one so I could push the extension  tubes through and have a safe magnetic way of keeping them accessible. all I have to do now is take off my seat to do a throttle  body sync and I have done this to me friends bike also and wanted to say if anyone would like me to do this for them I would be happy to do it for free, I will also be happy to sync your throttle bodies at the same time.
Regards
Andy

[Rusty Nuts]

Clever. Never lose the ends of the tubes again. But wait until you walk into the kitchen one dark morning and bang your head on a cabinet door that's sung open.

[Gert]

Thanks for sharing your tip on a nifty method of keeping the tubes together and easy accessible. How did you go about in blocking off the ends of each tube?

[Hessy]

I just used some plastic car panel clips and I put 6mm clips at both ends of the tubes to make sure they are air tight.
I used a 4mm id pipes so they were a snug fit also and used good quality pipe