Clutch not disengaging

[skatrekker]

Last week rode my DL1000 K2 for about 30 miles, no problems , running well etc. Today I can start it no problem but clutch will not free up when engaging 1st or 2nd gear. I have bled clutch line until clear of air , plenty of line pressure, checked the slave cylinder is moving freely. Tomorrow I will remove the front sproket and clean out all the crap etc and check the push rods but after that I don't know what else it could b be. Any Ideas my fellow Strommers ?

[kwackboy]

Could be a push rod issue as the position is directly in front of the front sprocket .

[skatrekker]

Cable tied the clutch lever overnight and found it now works perfectly so the plates must have stuck together with the oil . Have now ridden on two days, lots of stops, engine off still no issues