Author Topic: after market exhaust  (Read 1468 times)

0 Members and 1 Guest are viewing this topic.

Offline skink555

  • Member
  • ***
  • Joined: Aug 2015
  • Posts: 7
after market exhaust
« on: January 03, 2016, 09:06:52 »
Anyone fitted an after market end can?

Offline Joe Rocket

  • Member
  • ***
  • Joined: Sep 2014
  • Posts: 2593
  • Bike: DL650A L5, Kawasaki GPX750R
  • Location: Brittany
Re: after market exhaust
« Reply #1 on: January 03, 2016, 09:33:44 »
So how's it going so far then?

Offline Sea-Strom

  • Member
  • ***
  • Joined: Jan 2012
  • Posts: 795
  • Bike: DL1050A (2022), Fat Bob (2023), Softail Standard (2023)
  • Location: Swansea
Re: after market exhaust
« Reply #2 on: January 03, 2016, 19:43:07 »
All the info is in the above link. Bear in mind you can't just fit an end can. The 650 takes a 3/4 system which makes them fiddly to fit on the rear cylinder and a bit more expensive than a simple end can. However, it's well worth it to hear the gorgeous v-twin growl normally stifled by a stock exhaust. My money's on the Fuel but there are many alternatives out there. Go for it!

Offline Kayaker413

  • Member
  • ***
  • Joined: Jun 2015
  • Posts: 265
  • Bike: 2008 650
Re: after market exhaust
« Reply #3 on: January 05, 2016, 09:34:51 »
I have an MTC can on mine which sounds great but the quality is poor. I can easily ground the pipe at its lowest point (granted my peg is down at this point to) and it blows past the rivets. I assumed I hadn't sealed a joint fully...... Apparently not.
It is a far cry from the Arrow can I have on my old bike.
2008 650