Hi
After 32700 miles, and just returning from Corsica and Sardinia, I spotted that my headlamps (both) were not always on when the ignition was switched on.
A quick check, showed that there was something amiss under the front of the tank, where the wiring loom meets the headlight switch loom. So thinking the problem that the connector had come adrift, I took everything off to get to the little sucker.
Now, it looks fine and I have splashed in some ACF50 and all looks 'tickerty boo', but if you wiggle the loom in the connectors vicinity, the headlights go out, and on again if you keep wiggling.
So, as my inclination is to remove the connector, male and female, and put single connectors in there, help and suggestions are required.
Yours in anticipation.
Crazyhorse